Applied-engineering TransWarp Manual de usuario descargar pdf (Pagina 6)

Switch 8 on both blocks are used in combination to select the default TransWarp

speed. These switches should both be in the OPEN position for Full Warp

speed. If switch 8 of block 2 is CLOSED, the setting of switch 8 of block 1 is

ignored by the TransWarp circuitry. Figure 1 shows the possible combinations

and the corresponding TransWarp speeds.

Figure 1 TransWarp Switch Blocks

BLOCK 1 BLOCK 2

Full TransWarp (3.6 MHz) OPEN....................................................OPEN

Half TransWarp (1.7 MHz) CLOSED..................................................OPEN

Normal Apple (1 MHz) OPEN................................................... CLOSED

Normal Apple (1 MHz) CLOSED................................................ CLOSED

Figure 2 Sample Switch Configuration for Apple //e System

BLOCK 1 BLOCK 2

System Configuration: TransWarp Switch Settings:

Slot 1 Parrallel Printer Interface Card Block 2, Switch 1 CLOSED

Slot 2 Serial Interface Card Block 2, Switch 2 OPEN

Slot 3 TransWarp Block 2, Switch 3 CLOSED

Slot 4 Clock Card Block 2, Switch 4 OPEN

Slot 5 Bank Switch Memory Card Block 1, Switch 5 OPEN

Slot 6 Floppy Disk Controller Block 2, Switch 6 OPEN

Slot 7 Empty Block 2, Switch 7 CLOSED

TransWarp

Memory Card

slots

Periferal Card

slots

Press switch

here to CLOSE

Press switch

here to OPEN

1 2 3 4 5 6 7 8

Sin comentarios

Applied-engineering TransWarp Manual de usuario Pagina 6